美国的斜齿轮图纸的英文，仅供参考

admin

1.Quality: ANSI/AGMA 2000-a88-q11, full depth, full fillet.

2.FOR LEAD, CROWN, AND PROFILE TOLERANCES SEE DWG 54773379

3.CROWN DRIVEN GWAR ONLY

4.NORMAL PRESSURE ANGLE 20”

5.NORMAL DIAMETRAL PITCH 8

6.NORMAL CIRAULAR PITCH 0.3927

7.HELIX ANGLE:16.6011

8.BACKLASH TO BE 0.996” TO 0.008” ON 6.9784” CENTERS

9.MATERIAL: AISI 8620

10.CASE CARBURIZE TO 0.025” TO 0.040” EFFECTIVE FEPTH AFTER GRINDING AND HARDEN TO 57-61 RC, CORE HARDNESS

      TO BE 25-40 RC.

11.RETAINED A USTENITE – 5% MAXIMUM BY VISUAL INSPECTION.

12.EACH GEAR DEAR SET TO BE BOXED SEPARATELY AS A SET AND EACH GEAR MARKED WITH THE SET PART NUMBER ON THE OUTSIDE. EACH GEAR TO HAVE P/N AND SUPPLIER INENTIFICATION STAMPED. EACH GEAR TO HAVE P/N AND SUPPLIER IDENTIFICATION SATAMPED OR ELECTRIC ACID ETCHED AS SHOWN, APPROX. TEXT HGT..25’.

13.REMOVE ALL CHIPS FROM TAPPED HOLES.

NUMBER OF TEETH

HAND OF HELIX

LEAD OF HELIX

PIRTCH DIAMETER

BASE CIRCLE DIAMETER

ADDENDUM

WHOLE DEPTH

TRANSVERSE CIRCULAR

TOOTH THICKNESS WO/BL

NORMAL CIRCULAR

TOOTH THICKNESS WO/BL

admin

以下是网友翻译的，不一定对，仅供参考。

齿轮制造标准和精度等级：ANSI/AGMA 2000-A88，精度12级，全深，全倒角。
齿向、齿形修缘和渐开线轮廓公差按54773379图纸规定。
仅驱动齿轮鼓形修整。
齿形压力角20°
节径DP=10
齿距：0.3142
螺旋角：15.9355°
在齿轮啮合中心距5.5118”上，侧隙要求在0.006” ~0.010”之间。
齿轮材料：AISI 86208
渗碳层0.025”~0.040”有效深度，表面硬度为57~61Rc，芯部硬度25~40Rc。
残余奥氏体最大5%目测检查。
每个周转盒内只能装一个齿轮组，周转盒外标记齿轮组图号，齿轮表面须按图示部位用电蚀法标记零件号和供货商代码，字高约0.25。
攻丝后，去除螺纹孔内的铁屑。