- UID
- 47756
- 好友
注册时间2010-1-24
威望值 点
最后登录1970-1-1
激情值 点
积分101
认证分 分
齿轮币 枚
回帖0
|
這雙工系統,它是非常好的。很多年前,有局限性,(小套),但現在與新的食譜,你可以放心地使用90%的套。
銑刀,標準2,3.5,6,9,12英寸,可以切斷所有螺旋,
需要採取的“旋轉”,“傾斜”,這兩個糾正“計算”刀“,通過”幾個可以切斷所有的螺旋刀具庫存,在刀的區別,
它有一個安置的車輪和齒輪的位置,
然後總結:“旋轉”角角“傾斜”,“搖籃角”,“內部角度攝像頭”,報告滾動徑向(此為前方和後方鏈輪)(這輪和小齒輪相同),是集大小的螺旋““沒有任何設備的校正完成的工作!
你好
This duplex system, it is very nice. many years ago 'had limitations, (only small sets) but now with new recipes you can' safely use for 90% of the sets.
cutter with standard 2, 3.5, 6, 9, 12, inches, you can cut all the spirals,
need to adopt the "swivel" the "tilt", these two corrects the difference in the number of cutter "calculated" the number of cutter "adopted", with a few of the cutter stock you can cut all the spirals,
it has a placement for the wheel and a placement for the pinion,
then summing: angle "swivel" angle "tilt", "cradle angle", "internal angle machinery", report rolling (this the same for front and rear sprocket) radial (same for this wheel and pinion) is the set size spiral "without any correction of equipment "finished work!
hello |
|